What causes the impact of aerated block equipment system?
November 06, 2021
What causes the impact of aerated block equipment system?
Rapid economic development at the same time aerated block equipment as an alternative to red brick building materials, construction is convenient and widely used in construction projects. In the past, the aerated block equipment in order to improve the paint layer and aerated concrete bonding performance, paint before the need for water on the wall, but the wet wall in the drying process to shrink deformation, easy to crack, mortar layer easy.
Aerated block equipment
But because aerated concrete has a large water absorption, drying shrinkage, low surface strength, equipment systems subject to shock? Small thermal conductivity, which causes the small modulus of elasticity of aerated block and the existence of crushed state of the surface, such as performance, which leads to its plaster difficulty, plaster layer easily hollow drum, cracking and quality is difficult to ensure failure. The product has very high water retention, strong cohesion and good construction performance. Avoid cracking, aerated block equipment waterproof and seepage resistance, can save time and energy non-toxic characteristics.
The use of this product aerated concrete equipment can make aerated concrete soil and painting layer with the company, thermal shock resistance and durability greatly improved, avoid batch embedded layer and base off, batch embedded layer blister, cracking, improve the quality, reduce the difficulty of paint decoration construction, improve the progress of the project.
Aerated block equipment
Gas block equipment liquid flow reversal without buffer, electromagnetic reversing valve reversing action is too fast, the spool and valve body with too much clearance, etc. will cause hydraulic shock.
The ends of the hydraulic cylinder are not equipped with a buffer device or improperly adjusted stroke, and the piston collides with the cylinder head. Hydraulic cylinder buffer device of the check valve sealing effect is not good, such as gas block equipment end cover at the paper pad damage, piston and cylinder body hole with too large clearance, loose throttle nut or improperly adjusted, the outer edge of the piston ends and end cover bore with too large clearance, so that the triangular groove is not buffer effect.
